AIR PERMEABILITY TESTER
To evaluate the Air Permeability of nylon Parachute/supply dropping Fabric as per the technical data given below
Maximum width of fabric which
Can be tested : 1Meter
Area of test opening : 4 Sq cm
Capacity of suction device : 20,000 litre/hour
Rota meter : 2,000 to 2000 , litr/hour
Pressure drop indicator : 0 – 900 mm x 1 mm
(Digital with pea hold)
Range of testing : 150 to 1200 cm3/ cm2/ sec
IS 2970:1964: Specification for Cotton Fabrics for supply-dropping Parachutes
IS 11056-1984: Method for Determination of Air Permeability of FabricsNote: A Calibration Certificate from N.P.L or NABL accredited Lab shall be provided along with the machine.
A) DIGITAL BUTTON SNAP PULL OUT TESTER- Cap - 20 Kg.
Dai of Button Grip - 6mm to 25mm Provided with Imelda Japan Force Gauge & Stand along with all fixtures for pull out tester as per ASTM standard
B) BUTTON SNAP PULL OUT TESTER - Capacity - 20 Kg.
Dai of Button Grip - 6mm to 25 mm Provided with Imelda Japan Force Gauge & Stand along with all fixtures for pull out tester as per ASTM standard
De-Mattia Flex Tester
The apparatus consists of pairs of flat grips of each pair being positioned vertically above the other. One of the grips of each pair shall be capable of a reciprocating motion in a vertical plane; the rate of movement of the reciprocating grip being 5.0 + 0.2 Hz. Each pair of grips are so positioned that they are 70+1 mm apart when in the open position and 12.5 + 0.5 mm apart when in the closed position.
The specimen shall be taken from the selvedge and at least 1 m from the beginning or end of the piece. The sample should be cut in a way that it gives the maximum representation of the fabric to be tested. The standard specimen should be a rectangular one about 125 mm long and 37.5 + 1 mm wide. In every series of test, cut six test specimens, three parallel to the longitudinal direction and three parallel to the transverse direction. Please note that there is no test pieces contain the same threads of fabric in the direction to be tested.
Angle of oscillation of grips : 57.15 ± 0.1
Flexing frequency : 300 ± 10 cycles/minute
Maximum distance between each set of the opposite grips : 75 ± 2
Dimensions of test specimens : 125 x 37.5 mm
Maximum number of test Specimens : Six that can be tested At one timeMotor : ¼ HP single –phase 230 volts AC
DIGITAL TENSILE STRENGTH TESTER
With digital display of load and elongation having the following capacity
RANDOM TUMBLE PILLING TESTER
CREASE RECOVERY TESTER
(A) WASHING FASTNESS TESTER
(B) WASHING FASTNESS TESTER
(C) WASHING FASTNESS TESTER